The router is among the most versatile woodworking power tools available. It can be used to automate traditional carpentry techniques like creating mortice & tenon or dovetail joints right through to trimming modern materials like engineered wood or laminates. The versatility of this router is enhanced considerably by the great number of router bits and jigs that are accessible. Therefore, it’s no surprise that a router can be seen in most respectable carpenters’ tool vaults. Purchasing a router can be a challenging task. There’s a lot of technical jargon to understand. In this, we’ve summarised a few things to consider when you are contemplating investing in a router. It is, by no means, an exhaustive listing. Broadly speaking, routers can be divided into three categories which are heavy duty, medium duty, and light duty. The light duty routers are sometimes known as “handheld” routers. Light duty routers are just really intended for basic operations like trimming. Check out the following website, if you’re searching for more details about m2m 4g router.

They’re lightweight, not very powerful and are, therefore, intended for infrequent use. Medium duty routers are more lighter and powerful. They can be used to perform more demanding tasks and are designed to be used frequently. Heavy duty routers are at the top of the range varieties. They are the most effective and are intended to be used for daily milling operations. They may be used for hand milling and may also be table-mounted for use as stationary routers. Collet corresponds to where the router bit is connected to the router. The collet diameter is equivalent to the direction bit diameter. They are available in two sizes. The size of the bit also determines how much material can be routed out in one pass and thus affects the strain that is put on the router’s motor. It would be pertinent to navigate through the extensive selection of router bits available in the marketplace before deciding which router to purchase. Routers usually come with variable speed control.

This variable speed corresponds to how fast the motor, and for that reason, the router bit turns. While this isn’t a crucial requirement, it is worth paying a bit extra for it if your budget allows. As we learned earlier, the bigger the router bit, the more stuff it will remove with each pass. It is good practice to reduce the speed of the engine when using larger pieces to reduce the strain on the bit and, in the end, the motor. Soft start is a feature usually found in medium to heavy-duty routers. The soft start means that the when the engine is started, it gradually increases in speed. This is a useful feature to have as it means that the tool will not push or pull abruptly as you begin routing. This feature makes the whole routing operation smoother and can prolong the life of the router and router bits. Again, it is well worth going for a router with this attribute, if you budget permits.